Fort Worth Plumbing repairs and replaces sump pumps for homes in Fort Worth, TX. A pump that hums but moves no water, cycles nonstop, or never switches on usually needs a new float switch, check valve, or the whole unit. Call with the symptom and the pump's age so the repair-or-replace question can be settled quickly.
A sump pump only matters on the day the pit fills, so the failure you find is usually one that has been sitting there for months. The pump didn't break during the storm. The storm showed you it was already broken.
The fix depends on which part gave out, and the symptom tells you most of it before anyone opens the pit.
Which symptom points to which failed part?
Sound and behaviour narrow it down. A motor that runs loudly while the water level stays put is usually a worn impeller or a lost prime. A pump that kicks on and off every few seconds is often a stuck or tangled float, or a check valve that lets discharge water fall back into the pit.
- Hums, no pumping: seized motor or jammed impeller
- Never starts, water rising: float switch, power, or a dead motor
- Short-cycles: check valve or float position
- Runs dry and long: discharge line blocked or frozen-shut outlet
Should I repair the pump or replace it?
Replacement of a switch or check valve is a small job on a pump that is otherwise sound. A pump with a failed motor, a rusted housing, or an age you can't recall is a different conversation, because the next failure is already on its way.
If you are installing where there was no pump before, the pit, the discharge route away from the foundation, and the power supply all have to be planned together. Ask where the discharge water will end up, since dumping it beside the house defeats the purpose.
What should I check before calling?
Make sure the pump is plugged in and the outlet's reset button has not tripped. Lift the float by hand with the pit accessible and see whether the pump responds. Then note what you saw, because that detail shortens the diagnosis.
Fort Worth Plumbing works from 4109 Weber St in Fort Worth and covers homes across Fort Worth. The shop runs Mon–Sat 7:30 AM – 9:00 PM, Sun 9:00 AM – 6:00 PM.
Why does my sump pump run but not pump water out?
Most often the impeller is worn or the pump has lost its prime, and sometimes the discharge line is blocked. Either way the motor is working while nothing moves. Have it looked at before the next heavy rain.
How do I know if my sump pump needs replacing?
Constant cycling, rust on the housing, strange grinding, or a pump you can't date all point toward replacement. A single bad float switch or check valve is a repair instead.
Can a sump pump be installed where there isn't one now?
Yes, but it needs a pit, a discharge path away from the foundation, and a reliable power source. Ask for all three to be addressed in the quote.